www.pudn.com > ucosii_block.rar > READ.ME
Embedded Systems Building Blocks
Complete and Ready-to-Use Modules in C
Version 2.00
READ ME FILE
------------------------------- Installation ---------------------------------
Use the Install.bat file to decompress and transfer the ESBB files from the CD to your system.
Install.bat expects 2 arguments.
1. Load DOS and spedify the C: druve as the default drive.
2) Install the CD-ROM in your CD drive
3) Type:
:INSTALL [destination]
where: is the drive letter of your CD-ROM
[destination] is the drive letter where you want ESBB installed
----------------------------- REPORTING PROBLEMS -----------------------------
If you find a problem (i.e. bug) in any of the modules, do not hesitate
to report the problem(s) to either:
1) The publisher:
R & D Technical Books, Inc.
1601 West 23rd Street, Suite 200
Lawrence, Kansas 66046
(785) 841-1631
2) Through the INTERNET:
My address is Jean.Labrosse@uCOS-II.com
3) By checking out my web site:
www.uCOS-II.com
4) By writing to me:
Jean J. Labrosse
949 Crestview Circle
Weston, FL 33327
5) By calling me at:
(954) 217-2036
(954) 217-2037 (FAX)
Make sure that the problem you are reporting is in the module and not your
application. If you in fact discover a bug, call the publisher and see if
they are shipping the same version of the code that you are using.
If you are using an older version, you should first get the lastest
version from the publisher. Most likely, the bug has been found by someone
else and has been corrected. In this case, you can obtain an upgrade by
contacting the publisher (see SOFTWARE UPGRADES).
If you have the same version as the publisher then you may have uncovered
a problem. I will do my best to correct the problem and get an answer back
to you as quickly as possible.
/*$PAGE*/
------------------------------ SOFTWARE UPGRADES -----------------------------
It is virtually impossible to notify everybody that purchased the code
(i.e. the diskette) to tell them that a new version is available. You should
occasionally check my web site to see what the latest version of ESBB is:
www.uCOS-II.com
I would highly suggest that you resist changing the STYLE of the code
unless you don't mind spending many hours doing so everytime you upgrade.
------------------------------ ESBB RELEASE NOTES ----------------------------
June 1, 1999: V2.00
-------------------
1) This is the initial release of Embedded Systems Building Blocks, Complete
and Ready-to-Use Modules in C, Second Edition. Each module has its own
version as shown below:
AIO V2.00
CLK V2.00
COMM V2.00
DIO V2.00
KEY_MN V2.00
LCD V2.00
LED V2.00
PC V2.00
TMR V2.00
uC/OS-II V2.00
Anytime a bug is found in one of the modules, the version of: Embedded
Systems Building Blocks, Complete and Ready-to-Use Modules in C will
change. However, only the version of the corrected module will change.