www.pudn.com > ucosforcodewarrior-hc12.rar > PE_Error.h, change:2006-01-03,size:2959b


/** ################################################################### 
**     THIS BEAN MODULE IS GENERATED BY THE TOOL. DO NOT MODIFY IT. 
**     Filename  : PE_Error.H 
**     Project   : _2006_01_02_PE 
**     Processor : MC9S12H256CPV 
**     Beantype  : PE_Error 
**     Version   : Driver 01.00 
**     Compiler  : Metrowerks HC12 C Compiler 
**     Date/Time : 1/3/2006, 3:21 PM 
**     Abstract  : 
**         This bean "PE_Error" contains internal definitions 
**         of the error constants. 
**     Contents  : 
**         No public methods 
** 
**     (c) Copyright UNIS, spol. s r.o. 1997-2004 
**     UNIS, spol. s r.o. 
**     Jundrovska 33 
**     624 00 Brno 
**     Czech Republic 
**     http      : www.processorexpert.com 
**     mail      : info@processorexpert.com 
** ###################################################################*/ 
 
#ifndef __PE_Error_H 
#define __PE_Error_H 
 
#define ERR_OK           0             /* OK */ 
#define ERR_SPEED        1             /* This device does not work in the active speed mode. */ 
#define ERR_RANGE        2             /* Parameter out of range. */ 
#define ERR_VALUE        3             /* Parameter of incorrect value. */ 
#define ERR_OVERFLOW     4             /* Timer overflow. */ 
#define ERR_MATH         5             /* Overflow during evaluation. */ 
#define ERR_ENABLED      6             /* Device is enabled. */ 
#define ERR_DISABLED     7             /* Device is disabled. */ 
#define ERR_BUSY         8             /* Device is busy. */ 
#define ERR_NOTAVAIL     9             /* Requested value or method not available. */ 
#define ERR_RXEMPTY      10            /* No data in receiver. */ 
#define ERR_TXFULL       11            /* Transmitter is full. */ 
#define ERR_BUSOFF       12            /* Bus not available. */ 
#define ERR_OVERRUN      13            /* Overrun error is detected. */ 
#define ERR_FRAMING      14            /* Framing error is detected. */ 
#define ERR_PARITY       15            /* Parity error is detected. */ 
#define ERR_NOISE        16            /* Noise error is detected. */ 
#define ERR_IDLE         17            /* Idle error is detected. */ 
#define ERR_FAULT        18            /* Fault error is detected. */ 
#define ERR_BREAK        19            /* Break char is received during communication. */ 
#define ERR_CRC          20            /* CRC error is detected. */ 
#define ERR_ARBITR       21            /* A node losts arbitration. This error occurs if two nodes start transmission at the same time. */ 
#define ERR_PROTECT      22            /* Protection error is detected. */ 
#define ERR_UNDERFLOW    23            /* Underflow error is detected. */ 
#define ERR_UNDERRUN     24            /* Underrun error is detected. */ 
#define ERR_COMMON       25            /* Common error of a device. */ 
#define ERR_LINSYNC      26            /* LIN synchronization error is detected. */ 
 
#endif __PE_Error_H