www.pudn.com > Source_jtag.zip > Jflash.h

/****************************************************************************** 
** 
**  COPYRIGHT (C) 2000, 2001, 2002 Intel Corporation. 
** 
**  The information in this file is furnished for informational use  
**  only, is subject to change without notice, and should not be construed as  
**  a commitment by Intel Corporation. Intel Corporation assumes no  
**  responsibility or liability for any errors or inaccuracies that may appear  
**  in this document or any software that may be provided in association with  
**  this document.  
** 
**  FILENAME:       Jflash.h 
** 
**  PURPOSE:        General header for the Jflash utility 
** 
**  LAST MODIFIED:  $Modtime: 2/27/03 11:34a $ 
******************************************************************************/ 
#include 
#define VERSION_MAX_LENGTH	11 
 
char VERSION[VERSION_MAX_LENGTH] = {"5.01.003"}; 
 
 
enum CABLE_TYPES			// The different cable types Jflash currently supports 
	{ 
		Insight_Jtag, 
		Parallel_Jtag 
	}; 
 
 
#define LPT1 0x3bc	// hardware base address for parallel port 
#define LPT2 0x378	// the search order is LPT1 then 2 then 3 
#define LPT3 0x278	// first valid address found is used (re-order if needed for multiple ports) 
 
 
#define READ 0		// Flags used to modify the SA-1110 JTAG chain data depending on 
#define WRITE 1		// the access mode of the Flash Memory 
#define SETUP 2 
#define HOLD 3 
#define RS 4 
#define K3 5		// Added for Bulverde/Dimebox 
 
#define ENABLE 1 
#define DISABLE 0 
 
#define DRIVE 0 
#define HIZ 1    // high Z (impedance) 
 
#define IGNORE_PORT 0		// Flag used when accessing the parallel port 
#define READ_PORT 1		    // READ_PORT = 'read port', IGNORE_PORT = 'ignore port',  
                            //   using IGNORE_PORT will speed access 
#define IP IGNORE_PORT 
#define RP READ_PORT 
 
#define CONTINUE    0       // not the last instruction 
#define TERMINATE   1       // this is the last instruction, so go to EXIT-1 IR 
 
 
#define MAX_IN_LENGTH 100 // max length for user input strings 
#define STATUS_UPDATE 2	// time between updates of program/verify status in seconds 
 
 
#define FIRST_HALF_WORD_MASK	0x0000FFFF