www.pudn.com > 8202T_PDVD_4X16.rar > cfg_6500.h, change:2007-08-27,size:3688b

/*benosn 2005-07-08  merge HD DVD code*/ 
/* helm modified code, 051222*/ 
 
/*nono move to cfg_xxx.h 
#undef MP_BOARD_216_PIN_NON_SHARE      
#define MP_BOARD_256_PIN_NON_SHARE       
//#undef  INTERNAL_AUDIO_DAC  
#define MUTE_PULL_HIGH 
*/ 
 
 
#undef ROM_TACC_DEFAULT          //helm for performance issue, 051014 
#define ROM_TACC_DEFAULT    70 
 
 
#define DIP_CFG_ENABLE		      //wsf add 2005-11-7 14:01 
 
#define SUPPORT_HD_DVD 
 
#define SCALER_6500  //helm mark this and remove it to cfg_customer_8202d.h//nono open it.5-12-24 4:19 
//#define DAC_6500D  //eric lin,2006-07-06,6500 verD support video DAC  
#ifdef SUPPORT_HD_DVD 
//#undef DVD_SETUP_REENG 
//#undef SDRAM_BUS_32BITS 
 
//nono mark it.5-12-26 14:05 Need to refer the cfg_xxx.h 
//#undef DEFAULT_OSD_LANG 
//#define DEFAULT_OSD_LANG 1 /*chinese*/ 
 
#define DIGITAL_VIDEO_OUT //Must Mask #define SDRAM_BUS_32BITS to use 16 bits SDRAM width 
#ifdef DIGITAL_VIDEO_OUT 
	#ifdef MP_BOARD_256_PIN_NON_SHARE 
		#define CCIR656_TYPE1		//helm for 6500B CCIR656 Out from Pin164~173 (8202D 256pin)   
	#else  
		#define CCIR656_TYPE2		//ronnie for 6500C CCIR656 Out from Pin144~153 (8202D 216pin) 
	#endif 
#endif 
 
//=======select input audio format=============// 
 
#define SUPPORT_6500_SPDIF_INPUT  //hongfeng 2006/4/6 9:31 
//#define SUPPORT_6500_I2S_INPUT  //hongfeng 2006/4/6 9:31 
 
 
//#define DVI_AUDIO_MUTE    //tjf audio mute i/o is gpio37 2004-4-26  
#define DVI_I2C_SET       //tjf I2C set for dvi311 2004-4-26 11:44 
#define RESET_TO_DVI311   //tjf gpio 40 use to reset dvi311 
 
//#define HDCP_CUSTOM //Don't open for release code.chenzhao 2005-3-8 
#if 1//def HDCP_CUSTOM//chenzhao on 2005-3-7 17:47   
    #define HDCP_ON     0 
    #define HDCP_OFF    1 
#endif 
 
 
/*==========================================================================*/ 
#define Mode_576I               9 
#define Mode_1080P              8 
#define Mode_VGA     		7 
#define Mode_SVGA   		6 
#define Mode_XGA     		5 
#define Mode_SXGA		4 
#define Mode_480P		3 
#define Mode_576P		2 
#define Mode_720P60		1 
#define Mode_720P50		1 
#define Mode_1080i		0 
/*=========================================================================*/ 
 
//====================kevin add for HDMI with HDCP============== 
#define   HDMI 
//#define HDMI_SMC_CLE // benson add for SMC_CLE control in hdmi project 
//#define NEW_HDDVD_GPIO//add for new hddvd gpio config.chenzhao on 2004-12-14 16:8   
//#define NEW_HDMI_FLOW //for use new HDMI Flow,added by chenzhao on 2005-2-25 15:40   
//#define NO_311_ANALOG_OUTPUT //chenzhao on 2005-3-3 13:32   
 
//===================================================== 
 
#endif  //SUPPORT_HD_DVD 
 
#if defined(NEW_MP3_GUI)&&!defined(INDIGO_STYLE_FSGUI) 
//#define MP3_LARGE_GUI//jiangtao mark 070315 
#endif 
 
#ifdef MP3_LARGE_GUI 
#undef DIR_SCROLL_BAR 
#endif 
 
//#define SCART_TV_6500_USE_PIN110_111_112  //caoh 2006-7-4 02:24ÏÂÎç move from cfg 
#ifdef SCART_TV_6500_USE_PIN110_111_112 
    #define USE_6500_HI_CTRL_SCART_TO_RGB 
    //#define LOW_CTRL_SCART_TO_RGB 
    //#define HI_CTRL_TO_RELEASE_SCART 
    #define USE_6500_HI_CTRL_TO_RELEASE_SCART 
    //#define USE_6500_LOW_CTRL_TO_RELEASE_SCART 
    #define USE_6500_HI_CTRL_SCART_TO_DISPLAY_16B9 
    //#define LOW_CTRL_SCART_TO_DISPLAY_16B9 
#endif 
 
#ifndef SDRAM_BUS_32BITS  //caoh 2006-7-8 03:56ÏÂÎç  only for 16bit mode I2C 
#define HDMI_16_BIT_256PIN_BOARD 
#endif 
 
//#define HDDAC_USE_HALF_SWING   //caoh 2006-7-11 02:03ÏÂÎç  HDDAC use which current  
//#define HDDAC_USE_FULL_SWING 
//#define HDDAC_USE_QUART_SWING 
 
//#define TV_WANT_6500_AUDIO_MUTE   //caoh 2006-7-11 02:59ÏÂÎç only for some tv don't mute RAW and DTS audio